多项选择题
All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A (Choose two.)（）。
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
相关考题
-
多项选择题
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? （）
A.Core2(config)# interface f0/0 Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
-
单项选择题
Which type of EIGRP route entry describes a fesible successor？（）
A.a primary route，stored in the routing table
B.a backup route，stored in the routingt able
C.a backup route，stored in the topology table
D.A primary route，stored in the topology table -
单项选择题
无类路由协议路由表表目为三维组，其中不包括（）。
A.子网掩码
B.源网络地址
C.目的网络地址
D.下一跳地址
