多项选择题
EIGRP is being used as the routing protocol on the PassGuide network. Whiletroubleshooting some network connectivity issues，you notice a large number of EIGRP SIA（StuckinActive）messages. What causes these SIA routes（）
A.The neighboring router stops receiving ACK packets from this router.
B.The neighboring router starts receiving route updates from this router.
C.The neighboring router is too busy to answer the query(generally caused by high CPU utilization).
D.The neighboring router is having memory problems and cannot allocate the memory to process the query or build the reply packet.
相关考题
-
单项选择题
At which lay er of the OSI model does the Spanning Tree Protocol (STP) operate at（）
A.Lay er 5
B.Lay er 4
C.Lay er 3
D.Lay er 2
E.Lay er 1 -
多项选择题
Which two statements about the Cisco Aironet Desktop Utility (ADU) are true（）
A.The Aironet Desktop Utility （ADU ）profile manager feature can create and manage only one profile for the wireless client adapter.
B.The Aironet Desktop Utility (ADU) can support only one wireless client adapter installed and used at a time.
C.The Aironet Desktop Utility (ADU) can be used to establish the association between the client adapter and the access point , manage authentication to the wireless network , and enable encryption.
D.The Aironet Desktop Utility (ADU) and the Microsoft Wireless Configuration Manager can be used at the same time to configure the wireless client adapter. -
单项选择题
The network setup for this trouble ticket is shown in Figure 3. Trouble Ticket Statement DSW1 and R4 cannot ping R2’s loopback or R2’s s0/0/0/0.12 IPv6 address. Initial troubleshooting showsand R2 is not an OSPFv3 neighbor on R3. Configurationon R2 ipv6 unicast-routing! ipv6 router ospf 6 router-id 2.2.2.2! interface s0/0/0/0.23 ipv6 address 2026：：1：1/122 ConfigurationR3 ipv6 unicast-routing! ipv6 router ospf 6 router-id 3.3.3.3! interface s0/0/0/0.23 ipv6 address 2026：：1：2/122 ipv6 ospf 6 area 0 Figure 3 What is the solution of the fault condition？（）
A.Add ipv6 ospf 6 area 0 under S0/0/0/0.23 on R2
B.Add ipv6 ospf 6 area 6 under s0/0/0/0.23 on R2
C.Remove IPv6 address from s0/0/0/0.23 on R2
D.Enable IPv6 routing on s0/0/0/0.23 on R2
